DS460SDC-3 460 watts total output power: 460 watts +12 vdc standby output wide range input voltage: 40 - 72 vac special features ? active power factor correction ? 1u x 2u form factor ? +12 vdc output ? +12 vdc standby ? hot plug operation ? n + 1 redundant ? active current sharing ? built-in cooling fan ? i 2 c communication interface bus ? pmbus compliant ? eeprom for fru data ? two year warranty safety ? ul/cul 60950 (ul recognized) ? nemko 60950 ? cb certifcate and report ? ce mark (lvd) electrical specifcations input input ra nge 40 - 72 vac frequency dc inrush current 50 a maximum inrush current effciency 90% typical at full load, nominal line conducted emi fcc subpart j en55022 class b radiated emi fcc subpart j en55022 class b leakage current 0.15 ma hold up time 1 ms minimum output main dc voltage +12.3 v @ 36.0 a standby +12 v @ 2.3 a adjustment range factory set regulation 5% overcurrent +12 vdc; recover; trip point 120% - 150% of rated current overvoltage +12 vdc; 13.2 - 14.4 vdc +12 vsb; 13.6 - 15.0 vdc turn-on delay < 2 seconds main output rise time < 50 ms, monotonic rise data sheet power
logic control ps_present (s4) used to sense the number of power supplies in the system (operational or not) and provide hot plug insertion and removal functionality by controlling main outputs during hot plug insertion and removal by employing following circuitry. when the unit is removed from the system the fast shut down signal quickly turns off main outputs and discharges output capacitors. this signal is the shortest gold fnger pin on the signal connector to allow for last make, frst break confguration. psok (s6) combined indicator of dc input and main 12 v dc output. this is a three level signal to indicate different stages as follows: dc not ok and dc not ok C signal status shall be low (< 0.6 v) dc ok and dc not ok C signal status shall be low (< 0.6 v) dc ok and dc ok C signal status shall be high (> 3.0 v) dc not ok and dc ok C signal status shall be middle level (between 2 v and 2.5 v) dc ok threshold is defned as when the 12 v output is greater than 11.5 v dc not ok threshold is defned as when the 12 v output is less than 11.4 v & greater than 11.3 v i-mon (s7) provides both the load sharing function (as a feedback for output regulation droop function) and 12 v output current information. ps interrupt (s4) the signal behavior in response to certain operating condition changes in the power supply as defned in the firmware specifcation section. this signal shall be pulled up to maximum 5 v logic level external to the ps. ps on (s8) required to remotely turn on/off the power supply. pson# is an active low signal that turns on the main 12 v dc output. when this signal is not pulled low by the system, or left open, the 12 v output is turned off. this signal is pulled to a standby voltage by a pull-up resistor internal to the power supply. refer to on/off timing for timing diagram in trn. when in off or standby condition, the main 12 v dc output will be less than 50 mv with respect to output return. led indicator green = dc input present, 12 v output & 12 v standby in regulation off = overvoltage, overcurrent, overtemperature, undervoltage protection triggered. environmental specifcations operating temperature -10 c to 50 c storage temperature -40 c to +85 c altitude, operating 10,000 ft. electromagnetic susceptibility/input transients en61000-4-2, 4-3, 4-4, -4-5, 4-6, 4-11 rohs & lead-free compliant no tantalum caps humidity 5 to 90% rh, non-condensing shock and vibration specifcatons complies with astec std. specifcations, q3205 mtbf (demonstrated) 500k hrs at full load, 50 c ordering information model number nominal output voltage set point set point tolerance total regulation minimum current maximum current output ripple p/p over current stand-by air flow DS460SDC-3 12.3 vdc 0.2% 5% 1 a 36.0 a 120 mv 150% 12.0 v @ 2.3 a std DS460SDC-3-001 12.3 vdc 0.2% 5% 1 a 36.0 a 120 mv 150% 12.0 v @ 2.3 a rev *overcurrent latches off if overcurrent lasts over 1 second, otherwise it is auto recovery. DS460SDC-3 data sheet
mechanical drawings 243.2 model label 196.9 0.65 7.8 0. 6 136.9 (2x) 11.2 86.4 0.55 39.9 0. 5 9.5 9.9 8.0 40.5 0. 7 1.0 4.2 7.6 3.0 emi gasket (8x) standard air flow directio n 187.8 198.1 0. 6 70.86 led indicator DS460SDC-3 data sheet
connector defnitions dc input connector pin 1 dc+ pin 2 dc- pin 3 earth ground output connector - power blades pb1 v o pb2 v o pb3 v o pb4 rtn pb5 rtn pb6 rtn pb7 rtn pb8 rtn pb9 v o pb10 v o output connector - signal blades s1 vsb s2 vsb s3 reserved s4 ps interrupt s5 ps present s6 psok s7 i-mon s8 pson# s9 scl s10 sda s11 gnd s12 add0 s13 add1 s14 add2 s15 rtn s16 rtn e a r th g r oun d s 8 s 1 p b 1 p b 2 p b 3 p b 4 p b 5 p o w e r s u pp l y o u t pu t ca r d e dge ( t o p s i de ) s 9 s 1 6 p b 1 0 p b 9 p b 8 p b 7 p b 6 p o w e r s u pp l y o u t pu t ca r d e dge ( b o tto m s i de ) DS460SDC-3 data sheet
ds460s-ds 09jul2015 power/signal mating connectors and pin types reference on power supply mating connector or equivalent dc input connector terminal block wire awg #16 - #12 output connector pcb card edge (0.062) molex 459840007 (top mount) molex 459841122 (bottom mount) DS460SDC-3 data sheet worldwide offices americas 2900 s.diablo way tempe, az 85282 usa +1 888 412 7832 europe (uk) waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom +44 (0) 1384 842 211 asia (hk) 14/f, lu plaza 2 wing yip street kwun tong, kowloon hong kong +852 2176 3333 for more information: www.artesyn.com/power for support: productsupport.ep@artesyn.com while every precaution has been taken to ensure accuracy and completeness in this literature, artesyn embedded technologies assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. artesyn embedded technologies, artesyn and the artesyn embedded technologies logo are trademarks and service marks of artesyn embedded technologies, inc. all other names and logos referred to are trade names, trademarks, or registered trademarks of their respective owners. ? 2015 artesyn embedded technologies, inc. www.artesyn.com
|
